DoorKing 1802 Manual do Proprietário descarregar pdf (Página 26)

3.1.8 Programming Switch Inputs

This programming sequence will set how the two switch inputs on the telephone entry system control

board will operate. Switch input 1 is labeled PSW (postal switch) and is found on terminal 4 of the

main terminal strip. Switch input 2 is a two terminal auxiliary input located on the upper left hand

corner of the control board. These switch inputs can be programmed to activate their respective

relays (switch 1 - relay 1, switch 2 - relay 2). They can also be programmed so that switch 1 dials out

the phone number programmed in directory code 0, 00, 000, or 0000, and switch 2 dials out the

phone number programmed in directory code 1, 01, 001, or 0001. Each switch is programmed

independently.

Factory setting is: Switch input 1 = 0 (relay 1 activates), Switch input 2 = 0 (relay 2 activates).

1. Press *23 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Press 1* (beep) to set switch 1, or press 2* (beep) to set switch 2.

3. Press 0* (beep) to set the switch input to activate the relay, or press 1* (beep) to set

the switch input to dial-out a preprogrammed phone number.

4. Press 0# TOGETHER to end this programming step (beeeeeep).

3.1.9 Number of Rings to Answer

This programming sequence sets the number of rings to allow before the telephone entry system

answers a call placed to it. This programming sequence does not affect the number of times that a

resident’s telephone will ring when a call is placed from the entry system to the resident.

Factory setting = 02 (two rings).

1. Press *18 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the number of rings _ _ then press * (beep).

3. Press 0# TOGETHER to end this programming step (beeeeeep).

3.1.10 PBX Line Access Code Programming

If the telephone entry system is connected to a PBX telephone system rather than a dedicated C.O.

line, you may need to set the unit to dial a line access code prior to dialing the resident phone

number. Typically, the line access code is “9”, but check with the PBX system administrator to be

sure.

1. Press *21 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the line access code number _ then press * (beep).

3. Press 0# TOGETHER to end this programming step (beeeeeep).

NOTE: To change a line access number, enter the correct number in step 2. To

delete a line access number, enter # in step 2.

3.1.11 Star (*) Key Function

This programming sequence sets the function of the * key on the keypad during conversation. This

key can be set to hang-up the entry system when pressed during conversation, or it can be

programmed to touch-tone out during conversation.

Factory setting = 0 (hang-up).

1. Press *27 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Press 0* (beep) for hang-up, or press 1* (beep) for touch-tone.

3. Press 0# TOGETHER to end this programming step (beeeeeep).

Page 26 1802-065-D-8-08

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 52 53

Sem comentários

DoorKing 1802 Manual do Proprietário Página 26